TI Training Brochure 2005

Operating the TRF4903 With MSP430 Evaluation Kit in the 868 MHz European ISM Band

This document presents the major differences between the PCM270x and PCM270xC audio data converters.

This application report presents a strategy for high-speed and economical calibration and production programming of the bq27505 single-cell, gas gauge chipsets. Flowchart examples are provided, along

This application report presents the steps necessary to update the bq20z80 firmware and the EVM.

SN74SSQE32882 SN74SSQE32882ZALR Marking Information

A common application of TSB43AA82 (iSphynxII) is a 1394-enabled storage device. While there are solutions on the market targeted specifically at mainstream 1394 hard disk drives iSphynxII is different in that it provides the system designer additional flexibility. This makes it ideal for non-standard storage solutions such as MP3 players.This document shows a simple iSphynxII-based storage sol

This application note discusses the ways in which the LM2756 can be configured to drive the eight LEDs in numerous configurations.

Components in the bq3060 reference design are explained in this application report. Design analysis and suggested tradeoffs are provided where appropriate.

This application note discusses the design of isolated converters using simple switchers.

Factors That Determine Light Load PSM Switching Frequency for TPS6102x Boost Converters

Although current-feedback amplifiers (CFAs) have been in use for quite some time there is a reluctance to view them in the same light as voltage-feedback amplifiers (VFAs). For instance the gain-bandwidth curve of VFAs has a parallel in a transimpedance-bandwidth curve for CFAs. This parameter can be used to determine the closed-loop behavior of the CFA in same way that GBW can for the VFA. Not

The signal-to-noise ratio and bandwidth of the combination of the ACF2101 dual switched integrator and a low-level input current is exceptional when compared to the performance of a classical transimpedance amplifier. To further improve the ACF2101 signal-to-noise ratio a resistor can be added in series with the input sensor.

TPDxxx Preventing ESD Arcing in a Connector

With XDM1.0 the decoder does not have separate reference and display buffers. The reference buffers of the decoder are used for display as well. This helps in reducing the overall DDR utilization and DDR b/w.However this new arrangement changes the overall buffer management of the application. Now the application needs to manage the display and reference buffers using the new XDM 1.0 APIs. Thi

In today?s competitive computing and networking industry any equipment downtime due to component interconnects or bus failures impedes communication hinders productivity and hampers financial growth. In recognizing this increasingly costly unplanned downtime the industry introduced live-insertion technology to minimize the impact of any such failures. The live-insertion feature enables a networ

This document describes the GSM half-rate voice coding implementation on the TMS320C62xx processor (also called the vocoder). It discusses the system requirements and gives two levels of detail for the subroutines. The first level is designed for programmers who want to use the code in a basic GSM architecture. The second level is for programmers who want to see how the code is implemented for mod

This software demonstration combines real-time D1 Joint Photographic Experts Group (JPEG) encoding and decoding of images on the DM642 Evaluation Module (EVM) with networking functionality.

The JPEG standard pertains to compression of still images. Performing JPEG compression at the rate of 30 frames per second in isolation as individual images is known as motion JPEG (MJPEG). This demonstrat