28 Gbps EML Driver w/ Peak-Detector Features: 100Gb Ethernet ER4/ LR4 systems CFP/CFP2 or similar form factor modules Optical transceivers and pluggable modules Broadband gain stages and pre-amplifiers Broadband Test & Measurement Equipment

9.3 GHz Latched Comparator with RSPECL Output Stage Features: Equivalent input bandwidth: 9.3 GHz typical Propagation delay: 85 ps typical Overdrive and slew rate dispersion: 10 ps typical Input signal minimum pulse width: 60 ps typical Resistor programmable hysteresis Differential latch control Power dissipation: 140 mW typical 16-terminal, 3 mm × 3 mm, ceramic leadless chip carrier (LCC) 16-lead lead frame chip scale package (LFCSP)

14 Gbps, 2:1 Differential Selector with Programmable Output Voltage Features: Supports High Data Rates: up to 14 Gbps Differential or Single-Ended Operation Fast Rise and Fall Times: 19 / 20 ps Low Power Consumption: 221 mW typ Programmable Differential Output Voltage Swing: 500 - 1300 mVp-p Propagation Delay: 87 ps Single Supply: -3.3 V 24 Lead Ceramic 4x4 mm SMT Package: 16 mm2

Micropower, Dual, Single Supply, Precision Op Amps Features: Available in 8-Pin SO Package 50µA Max Supply Current per Amplifier 70µV Max Offset Voltage 180µA Max Offset Voltage in 8-Pin SO 250pA Max Offset Current 0.6µVP-P, 0.1Hz to 10Hz Voltage Noise 3pAP-P, 0.1Hz to 10Hz Current Noise 0.4µV/°C Offset Voltage Drift 200kHz Gain Bandwidth Product 0.07V/µs Slew Rate Single Supply Operation Input Voltage Range Includes Ground Output Swings to Ground while Sinking Current No Pull-Down Output Sources and Sinks 5mA Load Current

150MHz Video Multiplexers Features: −3dB Bandwidth: 150MHz 0.1dB Gain Flatness: 30MHz Channel-to-Channel Switching Time: 25ns Turn-On/Turn-Off Time: 25ns High Slew Rate: 300V/µs Disabled Output Impedance: 10M 50mV Switching Transient Channel Separation at 10MHz: > 90dB Differential Gain: 0.02% Differential Phase: 0.02° Wide Supply Range: ±5V to ±15V Output Short-Circuit Protected Push-Pull Output

Dual 200MHz, 30V/s 16-Bit Accurate AV 2 Op Amp Features: Stable in Gain AV ≥ 2 (AV = –1) 200MHz Gain Bandwidth Product 30V/μs Slew Rate Settling Time: 800ns (150μV, 10V Step) Specified at ±5V and ±15V Supplies Maximum Input Offset Voltage: 125μV Low Distortion: –96.5dB for 100kHz, 10VP-P Maximum Input Offset Voltage Drift: 3μV/°C Maximum Inverting Input Bias Current: 10nA Minimum DC Gain: 300V/mV Minimum Output Swing into 2k: ±12.8V Input Noise Voltage: 5nV/√Hz Input Noise Current: 0.6pA/√Hz Total Input Noise Optimized for 1kΩ < RS < 20kΩ Available in 8-Lead Plastic SO and 12-Lead (4mm × 4mm) DFN Packages

7A, 4.6A, 3A Low Dropout Fast Response Positive Regulators Adjustable and Fixed Features: Fast Transient Response Guaranteed Dropout Voltage at Multiple Currents Load Regulation: 0.05% Typical Trimmed Current Limit On-Chip Thermal Limiting Standard 3-Pin Power Package

Virtual Remote Sense Controller Features: Tight Load Regulation with Highly Resistive Cables without Requiring Remote Sense Wiring Compatible with Isolated and Nonisolated Power Supplies ±1% Internal Voltage Reference 5mA Sink Current Capability Soft-Correct Reduces Turn-On Transients Undervoltage and Overvoltage Protection Pin-Programmable Dither Frequency Optional Spread Spectrum Dither Wide VIN Range: 3.1V to 50V 24-Pin SSOP Package

Precision Zero-Drift Operational Amplifier with Internal Capacitors Features: No External Components Required Noise Tested and Guaranteed Low Aliasing Errors Maximum Offset Voltage: 5µV Maximum Offset Voltage Drift: 0.5µV/°C Low Noise: 1.6µVp-p (0.1Hz to 10Hz) Minimum Voltage Gain: 130dB Minimum PSRR: 125dB Minimum CMRR: 120dB Low Supply Current: 1mA Single Supply Operation: 4.75V to 16V Input Common Mode Range Includes Ground Output Swings to Ground Typical Overload Recovery Time: 3ms

3.3V Triple and Quad Video Amplifiers Features: Single Supply Operation from 3V to 12.6V Small (3mm x 5mm) MSOP 10-Lead Package Internal Resistors for a Gain of Two 340V/µs Slew Rate 110MHz –3dB Bandwidth 30MHz Flat to 0.25dB 3% Settling Time: 20ns Input Common Mode Range Includes Ground Rail-to-Rail Output High Output Drive: 60mA Operating Temperature Range: –40°C to 85°C 24-Bit RGB

8-Channel Analog Multiplexer with Cascadable Serial Interface Features: Low RON: 45 Single 2.7V to ±5V Supply Operation Low Charge Injection Serial Digital Interface Analog Inputs May Extend to Supply Rails Low Leakage: ±5nA Max Guaranteed Break-Before-Make TTL/CMOS Compatible for All Digital Inputs Cascadable to Allow Additional Channels Can Be Used as a Demultiplexer

3.3V Low Power EIA/TIA-562 Transceiver Features: Operates from a Single 3.3V Supply Low Supply Current: ICC = 200µA ICC = 35µA in Driver Disable Mode ICC = 0.2µA in Shutdown Mode ESD Protection Over ±10kV Uses Small Capacitors: 0.1µF Operates to 120kBaud Output Overvoltage Does Not Force Current Back into Supplies EIA/TIA-562 I/O Lines Can Be Forced to ±25V Without Damage Pin Compatible with LT 1180A

Micropower Op Amp, Comparator and Reference Features: Quiescent Current: 5µA Typ Outputs Swing Rail-to-Rail Low Op Amp Offset Voltage: 700µV Max Reference Output Drives 0.01µF Capacitor Internal 1.2V ±0.4% Reference Output (LTC1541) Low Input Bias Current: 1nA Max Reference Output Can Source Up to 2mA Internal ±2.25mV Comparator Hysteresis Comparator and Op Amp Input Range Includes Ground Op Amp Capable of Driving Up to 1000pF Load Unity-Gain Stable and 12kHz Bandwidth 2.5V to 12.6V Supply Voltage Range Pin Compatible Upgrade for MAX951/MAX953 Available in 3mm × 3mm × 0.8mm DFN Package

Micropower, Low Charge Injection, Quad CMOS Analog Switches Features: Micropower Operation Single 5V or ±15V Supply Operation Low Charge Injection Low RON Low Leakage Guaranteed Break Before Make Latch Resistant Design TTL/CMOS Compatible Improved Second Source for DG201A/DG202

Doubler Charge Pumps with Low Noise Linear Regulator Features: Low Output Noise: 60µVRMS (100kHz BW) Adjustable or Fixed Boosted Output Adjustable Output Voltage Range: 2.5V to 5.5V Fixed Output Voltages: 3.3V, 5V Wide Input Voltage Range: 1.8V to 4.4V Uses Small Ceramic Capacitors No Inductors Required Output Current up to 50mA 550kHz Switching Frequency Low Operating Current: 150µA Low Shutdown Current: 1µA Internal Thermal Shutdown and Current Limiting Available in 8-Pin MSOP and SO Packages

Ultralow Power Dual Comparators with Reference Features: Ultralow Quiescent Current: 3.5µA Typ Open-Drain Outputs Typically Sink Greater Than 20mA Wide Supply Range: (LTC1841) Single: 2V to 11V Dual: ±1V to ±5.5V Input Voltage Range Includes the Negative Supply Reference Output Drives 0.01µF Capacitor Adjustable Hysteresis 12µs Propagation Delay with 10mV Overdrive No Current Spike When Switching

10-Bit, 135Msps ADC Features: Sample Rate: 135Msps 61dB SNR up to 200MHz Input 75dB SFDR up to 400MHz Input 775MHz Full Power Bandwidth S/H Single 3.3V Supply Low Power Dissipation: 630mW CMOS Outputs Selectable Input Ranges: ±0.5V or ±1V No Missing Codes Optional Clock Duty Cycle Stabilizer Shutdown and Nap Modes Data Ready Output Clock Pin Compatible Family 135Msps: LTC2224 (12-Bit), LTC2234 (10-Bit) 105Msps: LTC2222 (12-Bit), LTC2232 (10-Bit) 80Msps: LTC2223 (12-Bit), LTC2233 (10-Bit) 48-Pin 7mm × 7mm QFN Package

Precision Quad Supply Monitor in 6-Lead SOT-23 Features: Ultralow Voltage Reset: VCC = 0.5V Guaranteed Monitor Four Inputs Simultaneously 3.3V, 2.5V, 1.8V, ADJ (LTC2903-A1) 5V, 3.3V, 2.5V, 1.8V (LTC2903-B1) 5V, 3.3V, 1.8V, –5.2V (LTC2903-C1) 3.3V, ADJ, ADJ, ADJ (LTC2903-D1) 5V, ADJ, ADJ, ADJ (LTC2903-E1) Guaranteed Threshold Accuracy: ±1.5% of Monitored Voltage over Temperature 10% (A1, B1, C1) and 5% (D1, E1) Undervoltage Monitoring Low Supply Current: 20µA Typical 200ms Reset Time Delay Active Low Open-Drain RST Output Power Supply Glitch Immunity Low Profile (1mm) SOT-23 (ThinSOT™) Package

3.3V 20Mbps RS485/RS422 Transceiver Features: 3.3V Supply Voltage 20Mbps Maximum Data Rate No Damage or Latchup Up to ±15kV HBM High Input Impedance Supports 256 Nodes (C, IGrade) Operation Up to 125°C (H-Grade) Guaranteed Failsafe Receiver Operation Over the Entire Common Mode Range Current Limited Drivers and Thermal Shutdown Delayed Micropower Shutdown: 5μA Maximum (C, I-Grade) Power Up/Down Glitch-Free Driver Outputs Low Operating Current: 370μA Typical in Receive Mode Compatible with TIA/EIA-485-A Specifications Available in 8-Pin and 10-Pin 3mm × 3mm DFN, 8-Pin and 10-Pin MSOP, and 8-Pin and 14-Pin SO Packages

Precision Quad Supply Monitor in 6-Lead SOT-23 Features: Ultralow Voltage Reset: VCC = 0.5V Guaranteed Monitor Four Inputs Simultaneously 3.3V, 2.5V, 1.8V, ADJ (LTC2903-A1) 5V, 3.3V, 2.5V, 1.8V (LTC2903-B1) 5V, 3.3V, 1.8V, –5.2V (LTC2903-C1) 3.3V, ADJ, ADJ, ADJ (LTC2903-D1) 5V, ADJ, ADJ, ADJ (LTC2903-E1) Guaranteed Threshold Accuracy: ±1.5% of Monitored Voltage over Temperature 10% (A1, B1, C1) and 5% (D1, E1) Undervoltage Monitoring Low Supply Current: 20µA Typical 200ms Reset Time Delay Active Low Open-Drain RST Output Power Supply Glitch Immunity Low Profile (1mm) SOT-23 (ThinSOT™) Package