EncodeDecode Demo for the DaVinci DVEVM/DVSDK 1.2 (Rev. A)
Texas InstrumentsEncodeDecode Demo for the DaVinci DVEVM/DVSDK 1.2 Application Report
Reading and Understanding an ESD Protection Datasheet
Texas Instruments<p>System engineers must choose all components for their designs carefully. Picking the right ESD protection elements can be challenging as the matter of protecting devices on the PCB against ESD str
AN-1412 Micro SMDxt Wafer Level Chip Scale Package (Rev. K)
Texas InstrumentsMicro SMDxt is a wafer level CSP (WLCSP) with the following features:
- Package size equal to die size
- Smallest footprint per I/O count
- No need for underfill material
- Interconnect layout available in 0.4 mm or 0.5 mm pitch
- No interposer between the silicon IC and the printed circuit board
Audio Echo on the DM642 EVM
Texas InstrumentsThe software demonstrates an audio loopback example on the DM642 EVM with programmable echo added to the input signal. The demonstration creates and primes the audio I/O streams initializes the echo buffer enters a loop reading audio samples then processes the samples and writes them back into the audio codec.
The demonstration:
- Computes the read pointer and adds a sample on each
System Testability Using Standard Logic (Rev. A)
Texas InstrumentsThe use of more sophisticated ASICs and microprocessors and a steadily increasing move toward surface-mount packaging has led to the increasing complexity and density of digital systems. These advances improve system performance and decrease the physical size of printed-circuit boards (PCBs) but complicate the task of system testing. Access to test nodes using bed-of-nails testing is red
bq27510-G1 - bq27510-G2 Change List
Texas Instrumentsbq27510-G2 bq27510-G1 - bq27510-G2 Change List
Generic Wrist Watch Programmer's Guide
Texas InstrumentsThis document provides information on the Wrist Watch RevD firmware architecture and the AFE44xx library. This document describes the basic architecture of the wrist watch firmware and how the AFE44xx
DN119 -- Asynchronous Serial Mode for CC111xFx and CC251xFx (Rev. A)
Texas InstrumentsDN119 -- Asynchronous Serial Mode for CC111xFx and CC251xFx
DN507 -- FEC Decoding
Texas InstrumentsThe purpose of this design note is to show how the FEC decoding implemented in HW on the CC1100 CC1100E CC1101 CC1110Fx CC1111Fx CC1150 CC2500 CC2510Fx CC2511Fx and CC2550 can be implemented in SW. This is in particular very important for the CC430Fx device which has the same radio as the CC1101 and CC1110/11Fx but without HW FEC included.
Using The PT6520 Series to Replace PT6500 Series Parts in Existing Designs
Texas InstrumentsUsing The PT6520 Series to Replace PT6500 Series Parts in Existing Designs
Supplying TPS61200 With a Single Solar Cell (Rev. B)
Texas InstrumentsThis application report explains how to use the TPS61200 in combination with a single solar cell to charge a battery or storage device. A characteristic of solar cells is the internal resistance that can vary from less than 10 Ω up to more than 100 Ω. Therefore it is important to control the load placed on the solar cell to ensure a reliable start-up of the application. This report describes an a
bq30z50/55 Gas Gauge Circuit Design
Texas Instrumentsbq30z50/55 bq30z50/55 Gas Gauge Circuit Design
C2000 Dual Sync Buck/Boost Converters
Texas InstrumentsC2000 Dual Sync Buck/Boost Converters written by Chinese engineer
Measuring the Packet Error Rate (PER) Using the TRF6903 w/MSP430 Evaluation Kit
Texas InstrumentsMeasuring the Packet Error Rate (PER) Using the TRF6903 With MSP430 Evaluation Kit
Extending the Reach of a FPD-Link II Interface with Cable Drivers and Equalizers (Rev. A)
Texas InstrumentsTI's family of embedded clock LVDS SER/DES (FPD-link II) provides a 2-wire serial interface for displayapplications up to distances of 10 meters.
Characteristics of Rechargeable Batteries
Texas InstrumentsCharacteristics of Rechargeable Batteries
Optimizing Digital Motor Control Libraries
Texas InstrumentsThe DMC library contains a collection of component modules and system implementations, which are intended for evaluation, accelerated design, and development of motor control firmware.<p>The software
TMS320C5x Interrupt Response Time
Texas InstrumentsThis document discusses the important issues in TMS320C5x interrupt latency/processing. In it the speed at which the TMS320C5x can recognize consecutive interrupts is calculated. This time depends on the interrupt latency and the time required to service the interrupt. A practical application a bar code scanner routine will be used as an example.
