This application note considers both the benefits and challenges of using high-frequency regulators.

AN-1294 COP8TAB9/TAC9 ISP HANDBOOK—Intro to ISP

TAS2552 Inductor Selection for the TAS2552 Boosted Class-D Amplifier

Mobitex a packetized wireless 900MHz wide area network (WAN) allows mobile/portable subscribers to transfer data including e-mail through the growing national and international network infrastructures. This document describes Mobitex DSP modems their characteristics and modulator design. The GMSK demodulator design is also presented.

Cobalt Dichloride Free Humidity Indicator Cards

The enhanced host port interface (EHPI) on the TMS320VC5509 and TMS320VC5510 DSPs provides a 16-bit port through which a host device may access the internal and external memory space of the DSP. The flexibility of the EHPI interface allows various host devices to interface with the DSP using minimal or no external interface logic. This document describes various possible EHPI configurations and ex

Partition IEEE 1149.1 SCAN Chains for Manageability!

TLC6C598-Q1, TLC6C5912-Q1 Shift Register LED Driver Application

It is commonly expected that very low distortion amplifiers must dissipate considerable quiescent power toachieve their high linearity. With the advent of intrinsically low distortion current feedback op amps alongwith the linearity improvements achieved by the negative feedback used in these devices wideband lowdistortion amplifiers have become available at much lower quiescent power leve

This application note shows the PGA900 used as a 2-wire 4- to 20-mA current loop transmitter a common method of transmitting sensor information in industrial process-monitoring applications. Transmitting sensor information (physical parameter measurements) through a current loop is particularly useful when the information must be sent to a remote location over long distances (1000 feet or more).

MSP430, bq26100, bq26100EVM, bq26150, bq26150EVM, bq26500, bq27000, bq27000EVM, bq27200, b MSP430 Microcontroller Software for Handheld Fuel Gauge & Battery Authentication

TI provides ten types of plastic-surface mount-packages for CMOS FIFO devices. This document discusses the thermal impedance package moisture sensitivity and packaging for these devices.

This document presents a checklist and a discussion on how to transfer reliably the bq27541 into Hibernate mode.

Texas Instruments has introduced a refined version of its nickel/palladium (NiPd) finish for integrated circuit (IC) package leads. The enhanced version of lead finish is nickel/palladium/gold (NiPdAu). TI has a long and successful history with the NiPd finish. There are more than 40-billion devices in the field with TI NiPd-finished leads. TI introduced the NiPd finish in 1989 and many papers a

The DSP Hardware Designer's Resource Guide is organized by development flow and functional areas to make your design effort as seamless as possible. Topics covered include getting started, board desi

This design was created to help those needing to power the SiRFatlasIV and doing so by implementing a highly integrated and efficient design using the TPS65072 power management unit.

Many applications require the ability to exchange modules in electronic systems without removing the supply voltage from the module (live insertion). For example an electronic telephone exchange must always remain operational even during module maintenance and repair. To avoid damaging components additional circuitry modifications are necessary. This document describes in detail the phenomena tha

Power Dissipation Analysis and Circuit Design for Sync Switching Battery Charger Using bqSWITCHER