Hot-Swappable, Dual I2C Isolators, 5 Kv

Hot-Swappable, Dual I2C Isolators, 5 Kv

18-Bit, 670 kSPS, Differential Programmable Input PulSAR ADC Features: Multiple pins/software-programmable input ranges 5 V (10 V p-p), +10 V (20 V p-p), ±5 V (20 V p-p), ±10 V (40 V p-p) Pins or serial SPI®-compatible input ranges/mode selection Throughput 670 kSPS (warp mode) 570 kSPS (normal mode); 450 kSPS (impulse mode) See datasheet for additional features

18-Bit, 670 kSPS, Differential Programmable Input PulSAR® ADC

Multiformat Video Encoder Six, 11-Bit, 297 MHz DACs

16-Bit, 0.5 LSB, 500 kSPS PulSAR Differential A/D Converter in MSOP/QFN Features: 16-bit resolution with no missing codes Throughput: 500 kSPS INL/DNL: ±0.25 LSB typ, ±0.5 LSB max (±8 ppm of FSR) Dynamic range: 96.5 dB SINAD: 96 dB at 1 kHz THD: −120 dB at 1 kHz True differential analog input range: ±VREF 0 V to VREF with VREF up to VDD on both inputs No pipeline delay Single-supply 5 V operation with 1.8 V/2.5 V/3 V/5 V logic interface Proprietary serial interface SPI®-/QSPI™-/MICROWIRE™-/DSP-compatible Daisy-chain multiple ADCs, selectable busy indicator Power dissipation: 40 nJ/conversion 40 μW at 5 V/1 kSPS 4 mW at 5 V/100 kSPS 18 mW at 5 V/500 kSPS Standby current: 1 nA 10-lead package: MSOP (MSOP-8 size) Pin-for-pin compatible with the 16-bit AD7687 and AD7688 and the 18-bit AD7690 and AD7691

Simultaneous Sampling Dual 175 kSPS 14-Bit ADC

CMOS Low Voltage 2 Ω SPST Switches

SPST, 1 Func, 1 Channel, CMOS, PDSO8

Dual-Channel Isolators with isoPower Integrated DC-to-DC Converter, 50 mW

Microprocessor Supervisory Circuits

ADM8693 - Microprocessor Supervisory Circuit

Microprocessor Supervisor with Backup Battery Switchover Features: Upgrade for the ADM690, ADM691, ADM695 and for the MAX690, MAX691, MAX695 Specified over temperature Low power consumption: 0.7 mW Precision voltage monitor Reset assertion down to 1 V VCC Low switch on resistance: 0.7 Ω normal, 7 Ω in backup High current drive: 100 mA Watchdog timer: 100 ms, 1.6 sec, or adjustable Standby current: 400 nA Automatic battery backup power switching Extremely fast gating of chip enable signals (3 ns) Voltage monitor for power fail Available in TSSOP package

Microprocessor Supervisory Circuit in 4-Lead SC70

Microprocessor Supervisory Circuit in 4-Lead SC70

Quad, 15 V, 256-Position Digital Potentiometer with Pin-Selectable SPI/I2C Features: 256-position, 4-channel End-to-end resistance 20 kΩ, 50 kΩ, 200 kΩ Pin-selectable SPI®- or I2C®-compatible interface Power-on preset to midscale Two package address decode pins AD0 and AD1 Rheostat mode temperature coefficient 30 ppm/°C Voltage divider temperature coefficient 5 ppm/°C Wide operating temperature range –40°C to +125°C 10 V to 15 V single supply; ±5 V dual supply

-48 V Full Feature Hot Swap Controller Features: Precision In-Rush Linear Current Limit Adjustable Soft Start In-Rush Current Limit Profiling Max On-Time Modulated by FET Drain Voltage for Additional SOA Protection Adjustable PWM Retry Scheme and Multiple Device Cascading Precision Maximum On Time in Current Limit Capability for Charging Large Capacitive Loads Shunt Regulator Topology Allows For Very Large Transient Input Supplies Precision UnderVoltage and OverVoltage Monitors with Separate UV and OV Pins and Programmable UV and OV Hysteresis

RF/IF Vector Multiplier

1700 MHz to 2400 MHz GAAS MATCHED RF PA PREDRIVER