Search results

The Intel® Core i7 power management design is a reference design for Intel IMVP-7 SVID. A GUI communication program is available along with several test points on the board to evaluate the static and dynamic performance of the CPU's DC/DC controller. The design features an IMVP-7 3-phase CPU supply: a 2-phase GPU Vcore supply: a 1.05-VCC IO supply: and a DDR3L/DDR4 memory rail. To greatly improve power density and thermal performance: 5-mm x 6-mm NEXFET power block MOSFETs are used.

low power inverting buck boost to generate negative output voltage -5.5V out of positive input voltage 15V

Successful circuit designs using high-speed amplifiers can depend upon understanding and identifying parasitic PCB components. Simulating a design while including PCB parasitics can protect against unpleasant production surprises. This application report discusses an easy method for measuring parasitic components in a prototype or final PC board design by using a standard oscilloscope and low freq

This reference design is a high efficiency dual charger designed with the UCC28610 + UCC24610 combination and 2 TPS2540 (USB switches). The UCC24610 provides quasi-resonant control and burst-mode for improved light-load efficiency and low standby power while the UCC24610 a green rectifier controller enables high efficiency at full load. The TPS2540 USB switch enables the charger to identify the host and provide the proper data line configuration.

BQ2057 Evaluation Module for Li-Ion, linear (4.1V), one cell

TS3DDR32611EVM - PCDDR3 Termination Regulator Evaluation Module Board

Evaluation Board for LM25085 - 42V Wide Vin Constant On-Time PFET Buck Switching Controller

ADS5463 12-bit 500-MSPS ADC evaluation module

32-MHz Arm Cortex-M0+ MCU with 32-KB flash, 4-KB SRAM, 12-bit ADC, comparator, OPA 24-VQFN -40 to 125

This EBV designed board is the ideal board to start first experiments based on Altera Cyclone III FGPAs.

100W lowest profile boost converter to supply sensitive: but constant RF load

Schottky Barrier Rectifiers: Single DO-41 If 1.0A Vrm 800V

DRV8836 Evaluation Module

LED drivers such as the TLC5940 provide many integrated features that require a microprocessor interface to use. When these features are not needed the TLC5940 can be configured with a single-wire interface for simple on/off control. This provides a low-cost solution to drive multiple LEDs with tight current matching while still allowing for PWM dimming in applications such as backlighting or gen

The PMP8764 reference design uses the UCC28700 primary-side regulated flyback controller to generate a 12V/250mA output from a 230VAC input. The valley switching of the UCC28700 allows this low-cost design to achieve a maximum load efficiency over 78%; no load losses are only 30mW.This circuit fits onto a 23mm x 37mm PCB.

TPS61032 Evaluation Module

Thin SOT23 1A Load Step-Down DC-DC Regulator Evaluation Module

9V to 21Vin; 3A Step Down Converter

INDUCTOR BOBINADO, 4.3NH, 6GHZ, 0.7A;