7B34 - IC Controller 14V - 35V Module Tray

SPST, 4 Func, 1 Channel, CMOS, PDSO16

Operational Amplifier, 1 Func, 10000uV Offset-Max, BIPolar, PDSO5

2.7 V, 800 A, 80 MHz Rail-to-Rail I/O Single Amplifier Features: Low power Supply current 800 µA/amplifier Fully specified at +2.7 V, +5 V and ±5 V supplies High speed and fast settling on 5 V 80 MHz, –3 dB bandwidth (G = +1) 30 V/µs slew rate 125 ns settling time to 0.1% Output current: 15 mA High grade option VOS (maximum) = 1.5 mV Rail-to-rail input and output No phase reversal with input 0.5 V beyond supplies Input CMVR extends beyond rails by 200 mV Output swing to within 20 mV of either rail Low distortion –62 dB @ 1 MHz, VO = 2 V p-p –86 dB @ 100 kHz, VO = 4.6 V p-p

AD5206 - 6-Channel Digital Potentiometer

Operational Amplifier, 1 Func, 1300uV Offset-Max, BIPolar, PDSO5

4-Channel 15 V/+12 V Multiplexer Features: 33 V Supply Range 130 Ω on Resistance Fully Specified at ±15 V/+12 V 3 V Logic-compatible Inputs Rail-to-rail Operation Break-before-make Switching Action 16-lead TSSOP and 16-lead SOIC_N Upgrade for the ADG508A/ADG509A

Compact, 800 mA, 3 MHz, Simple DVS, Buck Regulator Features: Input voltage: 2.3 V to 5.5 V Peak efficiency: 95% 3 MHz fixed frequency operation Low quiescent current: 23 μA Ultralow shutdown current: 0.2 μA (typical) VSEL pin for simple dynamic voltage scaling (DVS)  100% duty cycle low dropout mode Internal synchronous rectifier, compensation, and soft start Current overload and thermal shutdown protection Small, 6-ball, 1 mm × 1.5 mm WLCSP package

ADUM1300 - Triple-Channel Digital Isolator

Ultralow Power, 3-Lead, SOT-23, Microprocessor Reset Circuit, Active-Low Open-Drain Output, 0.5 A Supply Current Features: Ultralow supply current of 1 μA maximum (ADM6326/ADM6328) Accurate monitoring of 2.5 V, 3 V, 3.3 V, and 5 V rails Reset thresholds available in increments from 2.2 V to 4.63 V Glitch immunity from negative-going VCC transients 2 reset output options Push-pull RESET (ADM6326/ADM6346) Open-drain RESET (ADM6328/ADM6348) Minimum reset timeout of 100 ms Operating temperature range of −40°C to +85°C 3-lead SOT-23 package

Current & Power Monitors & Regulators Constant Current Source

256-Position Dual Channel SPI Digital Potentiometer Features: 2-Channel, 256-position potentiometer End-to-End Resistance  2.5kΩ, 10kΩ, 50kΩ, 100kΩ Compact 10-lead MSOP (3 mm x 4.9 mm) package Fast settling time: ts = 5 μs typical on power-up Full read/write of wiper register Power-On preset to midscale Single Supply: 2.7 V to 5.5 V Low Temperature  Coefficient 35 ppm/°C Low power, IDD = 6 µA maximum Wide operating temperature: –40°C to +125°C Evaluation board available Qualified for automotive applications

800mA Low-Vin LDO Regulator Features: Maximum output current: 0.8 A Input voltage range: 1.6 V to 3.6 V Very low dropout voltage: 70 mV @ 0.8 A load Initial accuracy: ±1% Accuracy over line, load, and temperature: ±2% 7 fixed output voltage options with soft start 0.75 V to 2.5 V (ADP1752) Low shutdown current: <2 μA Adjustable output voltage option with soft start 0.75 V to 3.0 V (ADP1753) High PSRR (See data sheet for details) 23 μV rms at 0.75 V output Stable with small 4.7 μF ceramic output capacitor Excellent load and line transient response

800mA Low-Vin LDO Regulator Features: Maximum output current: 0.8 A Input voltage range: 1.6 V to 3.6 V Very low dropout voltage: 70 mV @ 0.8 A load Initial accuracy: ±1% Accuracy over line, load, and temperature: ±2% 7 fixed output voltage options with soft start 0.75 V to 2.5 V (ADP1752) Low shutdown current: <2 μA Adjustable output voltage option with soft start 0.75 V to 3.0 V (ADP1753) High PSRR (See data sheet for details) 23 μV rms at 0.75 V output Stable with small 4.7 μF ceramic output capacitor Excellent load and line transient response

Special Purpose Amplifiers PLC OUR DRIVER +/-24V I.C.

Analog Comparators 4ns Dual R2R Comparator