This application note looks at implementing a software-based UART which using general-purpose input/outputs (GPIO) allows the user to overcome hardware limitations or lack of dedicated peripherals.

Spreeta Application Brief 002

The most common reason for accessing memory-mapped registers is to control the 'C5x peripherals. This document discusses how to access the TMS320C5x memory-mapped registers in C.

This application report is written to help design engineers implement a stable DAC external reference circuit for TI's digital-to-analog converters (DACs) that do not have an internal reference. This report points out the critical aspects and the importance of a reference buffer driver.

The TPIC43T01 is an integrated motor controller designed to provide precision RPM (revolution-per-minute) control to a 3-phase brushless dc motor. The TPIC43T01 outputs are pre-drivers for six externa

The purpose of this application report is to provide help setting up the cyclic redundancy check (CRC) controller of the Hercules™ TMS570 and RM4 microcontrollers. The Hercules microcontrollers from Texas Instruments are 32-bit RISC microcontrollers based on the ARM® Cortex™-R4 core with an advanced architecture and a rich peripheral set that supports on-chip diagnostics to a

This application report discusses the LP3936 Lighting Management System.

The ADS1240 and ADS1241 are precision wide dynamic range delta-sigma (ΔΣ) Analog-to-Digital converters (ADCs) with 24-bit resolution. This application report describes the process of overclocking these low speed and low current consumption devices allowing them to run considerably faster while maintaining performance at the expense of current consumption.

TRF3765 REF_IN Impedance Application Note HPA/HSP/HS_Amps_RF/2-App_Reports/SLWA067_TRF3765/TRF3765

Cerpack

This application report discusses a method by which the Texas Instruments TMS320C62x? high-performance fixed-point digital signal processors (DSPs) overcome the traditional advantage held by floating-point DSPs ? precision and speed.

Using the Radix-4 Fast Fourier Transform (FFT) this document illustrates how extended precision arithmetic multiplication in particular can be performed on the

Maximizing Signal-Path Performance

How to Create a HalCoGen Based Project For CCSv4.x Application Report MCU_SPNA121A_ZHCA473A | ASPH/Auto_MC/AR

This application note applies to the TI average current mode leading edge modulation PFC controllers. See Applicable Device Table for part numbers.

This application report describes how you can begin development now for the Texas Instruments (TI) TMS320C6711 digital signal processor (DSP) systems. Because of the compatibility between TMS320C6000 generation devices existing ?C6000 software tools and development platforms can be used to develop code for the ?C6711 and other future devices. This capability allows for systems to be up and runnin

This document gives a complete overview of the register settings required to adjust the output power of the CC1100/1 and CC1150 devices. The tables within this document include typical output power harmonics and current consumption at the different register settings.

This application report describes how to communicate with the Hercules™ UART bootloader. The UART bootloader is a small piece of code that can be programmed at the beginning of Flash to act as an application loader as well as an update mechanism for applications running on a Hercules Cortex™-R4 based TMS570LS12x microcontroller.