Blackfin Embedded Processor with Codec

BLACKFIN EMBEDDED Processor with Codec

Low Power Blackfin Processor with Advanced Peripherals and Embedded Stereo Audio CODEC Features: Lockbox™ Secure Technology: Hardware-enabled security for code and content protection. Blackfin Processor Core with up to 400 MHz (800 MMACS) performance 2 dual-channel, full-duplex synchronous serial ports supporting 8 stereo I2S channels 12 peripheral DMA channels supporting one- and two-dimensional data transfers NAND Flash Controller with 8-Bit interface for commands, addresses and data. Ethernet 10/100 MII interface Memory controller providing glue-less connection to multiple banks of external SDRAM, SRAM, Flash, or ROM Low Processor Standby Power; ~1mA Deep Sleep, ~50uA Hibernate 289-ball, 12x12 mm, 0.5 mm pitch mini-BGA (Commercial temperature range 0°C to +70°C) Supports an embedded low power stereo CODEC for space constrained audio applications

Industrial I/V Output Driver, Single-Supply, 55 V Maximum Supply, Programmable Ranges

6-Channel, Low Noise, Low Power, 24-/16-Bit - ADC with On-Chip In-Amp and Reference

6-Channel, Low Noise, Low Power, 24-/16-Bit - ADC with On-Chip In-Amp and Reference

Low Voltage, Micropower, Quad Operational Amplifier

Nonvolatile, I2C Compatible 256-Position, Digital Potentiometer Features: Nonvolatile memory maintains wiper settings 256-position Thin LFCSP-10 (3 mm x 3 mm x 0.8 mm) package Compact MSOP-10 (3 mm × 4.9 mm × 1.1 mm) package I2C-compatible interface VLOGIC pin provides increased interface flexibility End-to-end resistance 5 kΩ, 10 kΩ, 50 kΩ, 100 kΩ Resistance tolerance stored in EEPROM (0.1% accuracy) Power-on EEPROM refresh time < 1ms Software write protect command Address Decode Pin AD0 and Pin AD1 allow 4 packages per bus 100-year typical data retention at 55°C Wide operating temperature −40°C to +125°C 3 V to 5 V single supply

Full K-Type Range 25 to 100 Thermocouple Amplifier w/Cold Junction Compensation Features: Low cost and easy to use Pretrimmed for K type thermocouples Internal cold junction compensation High impedance differential input Standalone 5 mV/°C thermometer Reference pin allows offset adjustment Thermocouple break detection See data sheet for additional features.

24-Bit, 15 mW, 109 dB, 128 kSPS/64 kSPS/32 kSPS ADCs Features: Oversampled successive approximation (SAR) architecture High performance ac and dc accuracy, low power 115.5 dB dynamic range, 32 kSPS (AD7767-2) 112.5 dB dynamic range, 64 kSPS (AD7767-1) 109.5 dB dynamic range, 128 kSPS (AD7767) −118 dB THD Exceptionally low power 8.5 mW, 32 kSPS (AD7767-2) 10.5 mW, 64 kSPS (AD7767-1) 15 mW, 128 kSPS (AD7767) High dc accuracy 24 bits, no missing codes (NMC) INL: ±3 ppm (typical), ±7.6 ppm (maximum) Low temperature drift Zero error drift: 15 nV/°C Gain error drift: 0.4 ppm/°C On-chip low-pass FIR filter Linear phase response Pass-band ripple: ±0.005 dB Stop-band attenuation: 100 dB 2.5 V supply with 1.8 V/2.5 V/3 V/3.6 V logic interface options Flexible interfacing options Synchronization of multiple devices Daisy-chain capability Power-down function Temperature range: −40°C to +105°C

300 mA, Low Quiescent Current, CMOS Linear Regulators

Low Cost, Miniature Isolation Amplifiers

SPDT, 2 Func, 1 Channel, CMOS, PDSO16

Dual SPDT Switch

Precision, Low Cost, High Speed, BiFET Op Amp

2.7 V to 5.5 V, Serial-Input, Voltage-Output, 14-Bit DACs

2.7 V to 5.5 V, Serial-Input, Voltage-Output, 14-Bit DACs Features: Full 14-Bit Performance 3 V and 5 V Single Supply Operation Low 0.625 mW power dissipation Fast 1 μs settling time Unbuffered Voltage Output Capable of Driving 60 k Loads Directly SPI™/QSPI™/MICROWIRE™ -Compatible Interface Standards Power-on reset clears DAC output to 0 V (unipolar mode) 5 kV HBM ESD classification

Picoampere Input Current Quad Bipolar Op Amp Features: High dc precision 150 μV maximum offset voltage 1.5 μV/°C maximum offset voltage drift 270 pA maximum input bias current 0.3 pA/°C typical IB drift Low noise: 0.5 μV p-p Typical noise: 0.1 Hz to 10 Hz Low power: 600 μA maximum supply current per amplifier Dual version: AD706

Low Power, Low Noise, Low Bias Current, Precision Dual RRO Op Amp Features: Low offset voltage: 125 μV max Supply current: 215 μA/amp typ Input bias current: 200 pA max Low input offset voltage drift: 1.2 μV/°C max Low voltage noise: 11 nV/√Hz Operating temperature range: −40°C to +125°C Rail-to-rail output swing Unity gain stable ±2.5 V to ±15 V operation

800mA Low-Vin LDO Regulator Features: Maximum output current: 0.8 A Input voltage range: 1.6 V to 3.6 V Very low dropout voltage: 70 mV @ 0.8 A load Initial accuracy: ±1% Accuracy over line, load, and temperature: ±2% 7 fixed output voltage options with soft start 0.75 V to 2.5 V (ADP1752) Low shutdown current: <2 μA Adjustable output voltage option with soft start 0.75 V to 3.0 V (ADP1753) High PSRR (See data sheet for details) 23 μV rms at 0.75 V output Stable with small 4.7 μF ceramic output capacitor Excellent load and line transient response