Micropower, 600kHz PWM DC/DC Converters Features: 100µA Quiescent Current Operates with VIN as Low as 1.5V 600kHz Fixed Frequency Operation Starts into Full Load Low-Battery Detector Active in Shutdown Automatic Burst Mode Operation at Light Load (LT1317) Continuous Switching at Light Loads (LT1317B) Low VCESAT Switch: 300mV at 500mA Pin for Pin Compatible with the LT1307/LT1307B

100mA, Low Voltage, Very Low Dropout Linear Regulators Features: VIN Range: 0.9V to 10V Minimum Input Voltage: 0.9V Dropout Voltage: 150mV Typical Output Current: 100mA Adjustable Output (VREF = VOUT(MIN) = 200mV) Fixed Output Voltages: 1.2V, 1.5V, 1.8V Stable with Low ESR, Ceramic Output Capacitors (2.2µF Minimum) 0.2% Load Regulation from 1mA to 100mA Quiescent Current: 120µA (Typ) 3µA Typical Quiescent Current in Shutdown Current Limit Protection Reverse-Battery Protection No Reverse Current Thermal Limiting with Hysteresis 8-Lead DFN (3mm × 3mm) and MSOP Packages

Negative Voltage Hot Swap Controller Features: Allows Safe Board Insertion and Removal from a Live –48V Backplane Operates from –10V to –80V Programmable Inrush Current Programmable Electronic Circuit Breaker Programmable Overvoltage Protection Programmable Undervoltage Lockout Power Good Control Output

Precision, Gain Selectable High Side Current Sense Amplifier Features: Input Offset Voltage: 300µV (Max) Sense Inputs Up to 48V 0.5% Gain Accuracy Pin Selectable Gain: 10, 12.5, 20, 25, 40, 50V/V Separate Power Supply: 2.7V to 36V Operating Current: 60µA Sense Input Current (VCC Powered Down): 1nA Reverse Battery Protected to –48V Buffered Output Noise Filtering Input –40°C to 125°C Operating Temperature Range Available in 8-Lead DFN and MSOP Packages

High Speed, 16-Bit, 333ksps Sampling A/D Converter with Shutdown Features: A Complete, 333ksps 16-Bit ADC 90dB S/(N+D) and –100dB THD (Typ) Power Dissipation: 220mW (Typ) No Pipeline Delay No Missing Codes over Temperature Nap (7mW) and Sleep (10µW) Shutdown Modes Operates with Internal 15ppm/°C Reference or External Reference True Differential Inputs Reject Common Mode Noise 5MHz Full Power Bandwidth ±2.5V Bipolar Input Range 36-Pin SSOP Package

Low Power RS485 Transceiver with Carrier Detect and Receiver Fail-Safe Features: No Damage or Latchup to ±15kV (Human Body Model), IEC1000-4-2 Level 4 (±8kV) Contact and Level 3 (±8kV) Air Discharge Active Low Carrier Detect Output Guaranteed High Receiver Output State for Floating, Shorted or Terminated Inputs with No Signal Present Drives Low Cost Residential Telephone Wires Low Power: ICC = 700µA Max with Driver Disabled ICC = 900µA Max in Driver Mode Without Load 20µA Max Quiescent Current in Shutdown Mode Single 5V Supply –7V to 12V Common Mode Range Permits ±7V Ground Difference Between Devices on the Data Line Maximum Data Rate of 4Mbps Power Up/Down Glitch-Free Driver Outputs Up to 32 Transceivers on the Bus Available in 8-Lead MSOP, PDIP and SO Packages

2-Wire Bus Buffers with High Noise Margin Features:Bidirectional Buffer Increases FanoutHigh Noise Margin with VIL = 0.3•VCCCompatible with Non-Compliant I2C Devices That Drive a High VOLStrong (LTC4313-1) and 2.5mA (LTC4313-2) Rise Time Accelerator CurrentLevel Shift 1.5V, 1.8V, 2.5V, 3.3V and 5V BussesPrevents SDA and SCL Corruption During Live Board Insertion and Removal from BackplaneStuck Bus Disconnect and RecoveryCompatible with I2C, I2C Fast Mode and SMBus±4kV Human Body Model ESD RuggednessHigh Impedance SDA, SCL Pins When Unpowered8-Lead MSOP and 8-Lead (3mm × 3mm) DFN Packages

LTC7138 - High Efficiency, 140V 400mA Step-Down Regulator

High Power PD with Synchronous No-Opto Flyback Controller Features: Robust 35W PD Front End IEEE 802.3af Compliant Rugged 750mA Power MOSFET with Precision Dual Level Current Limit High Performance Synchronous Flyback Controller IEEE Isolation Obtained Without an Opto-Isolator Adjustable Frequency from 50kHz to 250kHz Tight Multi-Output Regulation with Load Compensation On-board 25k Signature Resistor Programmable Classification Current to 75mA Complete Thermal and Over-Current Protection Available in Compact 32-Pin 7mm × 4mm DFN Package

1826-1349 SELECTED SPN IC

High Speed, Low Noise Quad Operational Amplifier

LT4276B, LT4321 Power over Ethernet (PoE) Power Management Evaluation Board

AD80264 - Application Specific Devices

130V Max Offset voltage Op Amp in TSOT23 Features: Low Offset Voltage: 130μV max Input Offset Drift: 1.5 µV/°C Max Supply Current: 1.1mA/amp Small 5-lead TSOT23 package Dual Supply Operation: ±5V to ±15V

Dual, High Voltage Current Shunt Monitor Features: ±4000 V human body model (HBM) ESD High common-mode input voltage range −2 V to +65 V operating −3 V to +68 V survival Buffered output voltage Wide operating temperature range −40°C to +125°C for Y grade −40°C to +150°C for H grade Excellent ac and dc performance −10 ppm/°C typical gain drift 120 dB typical CMRR at dc Qualified for automotive applications

40 A Micropower Instrumentation Amplifier Features: Low power: 40 μA supply current (maximum) Low input currents 1 pA input bias current 0.5 pA input offset current High CMRR: 110 dB CMRR, G = 100 Space-saving MSOP Zero input crossover distortion Rail-to-rail input and output Gain set with single resistor Operates from 1.8 V to 5.5 V

AD8302ARU-REEL7 REEL

1 MHz TO 8 GHz, 70 dB Logarithmic Detector/Controller Features: Wide bandwidth: 1 MHz to 8 GHz High accuracy: ±1.0 dB over 55 dB range (f < 5.8 GHz) Stability over temperature: ±0.5 dB Low noise measurement/controller output (VOUT) Pulse response time: 10 ns/12 ns (fall/rise) Integrated temperature sensor Small footprint LFCSP Power-down feature: <1.5 mW at 5 V Single-supply operation: 5 V @ 68 mA Fabricated using high speed SiGe processAD8138-EP supports defense and aerospace applications (AQEC standard) Download AD8318-EP data sheet (pdf) V62/12665 DSCC Drawing Number

5 V CATV Line Driver Fine Step Output Power Control Features: Supports DOCSIS Standard for Reverse Path Transmission Gain Programmable in 0.75 dB Steps Over a 59.45 dB Range Low Distortion at 61 dBmV Output –57 dBc SFDR at 21 MHz –55 dBc SFDR at 42 MHz Output Noise Level: –48 dBmV in 160 kHz Maintains 75Ω Output Impedance Transmit Enable and Transmit Disable Modes Upper Bandwidth:100 MHz (Full Gain Range) 5 V Supply Operation Supports SPI Interfaces

Dual VGA with Ultralow Noise Preamplifier and Programmable RIN Features: Ultralow noise preamplifier (preamp) Voltage noise = 0.74 nV/√Hz Current noise = 2.5 pA/√Hz 3 dB bandwidth: 100 MHz Low power: 145 mW/channel Wide gain range with programmable postamp −4.5 dB to +43.5 dB in LO gain mode 7.5 dB to 55.5 dB in HI gain mode Low output-referred noise: 48 nV/√Hz typical Active input impedance matching Optimized for 10-bit/12-bit ADCs Selectable output clamping level Single 5 V supply operation AD8332 and AD8334 available in lead frame chip scale package