3.8-V to 36-V, 3-A Synchronous Step-Down Voltage Converter 12-VQFN-HR -40 to 125

16-Channel, 16-Bit ES-PWM constant-current LED driver 24-SSOP -40 to 85

Operational Amplifiers - Op Amps 1.8V 2.9uA 90kHz Rail-to-Rail I/O

RS-485 Interface IC Low-power Half-dplx Transceiver

Encoders, Decoders, Multiplexers & Demultiplexers 3 to 8-Line Decdr/Demltplxer

Audio A/D Converter ICs Full Diff Anlg Inp 24-Bit 192KHz Ster

Operational Amplifiers - Op Amps Quad Low-Voltage Low Power RRO

RS-485 Interface IC Trans Volt Spprssn Diff Transceiver

RS-485 Interface IC Half-Duplex RS-485 Transceiver

Analog Comparators Dual Nanopower Open Drain Out Comparator

Buffers & Line Drivers Quad Bus Buff Gate With 3-State Outputs

Hot Swap Voltage Controllers Pwr Mngr for Redund -48V Supplies

Encoders, Decoders, Multiplexers & Demultiplexers 8Ln To 3Ln Priority Encoders

Power Switch ICs - Power Distribution Crnt-Ltd Pwr-Dist Sw

Reinforced Isolated Amplifier With 50mV Input and High CMTI 8-SOIC -55 to 125

SimpleLink Multiband CC1352R Wireless MCU With Integrated Power Amplifier 48-VQFN -40 to 85

The CC1352P device is a multiprotocol Sub-1 and 2.4-GHz wireless MCU targeting Wireless M-Bus, IEEE 802.15.4g, IPv6-enabled smart objects (6LoWPAN), Thread, Zigbee®, KNX RF, Wi-SUN®, Bluetooth® 5 low energy, and proprietary systems. The device contains a +20-dBm integrated high-power amplifier with best-in-class efficiency for long-range applications. The CC1352P device is a member of the CC26xx and CC13xx family of cost-effective, ultra-low power, 2.4-GHz and Sub-1 GHz RF devices. Very low active RF and microcontroller (MCU) current, in addition to sub-µA sleep current with up to 80KB of RAM retention, provide excellent battery lifetime and allow operation on small coin-cell batteries and in energy-harvesting applications. The CC1352P device combines a flexible, very low-power RF transceiver with a powerful 48-MHz Arm® Cortex®-M4F CPU in a platform supporting multiple physical layers and RF standards. A dedicated Radio Controller (Arm® Cortex®-M0) handles low-level RF protocol commands that are stored in ROM or RAM, thus ensuring ultra-low power and great flexibility. The low power consumption of the CC1352P device does not come at the expense of RF performance; the CC1352P device has excellent sensitivity and robustness (selectivity and blocking) performance. The CC1352P device is a highly integrated, true single-chip solution incorporating a complete RF system and an on-chip DC/DC converter. Sensors can be handled in a very low-power manner by a programmable, autonomous ultra-low power Sensor Controller CPU with 4KB of SRAM for program and data. The Sensor Controller, with its fast wake-up and ultra-low-power 2-MHz mode is designed for sampling, buffering, and processing both analog and digital sensor data; thus the MCU system can maximize sleep time and reduce active power. The CC1352P device is part of the SimpleLink™ microcontroller (MCU) platform, which consists of Wi-Fi®, Bluetooth® low energy, Thread, Zigbee, Sub-1 GHz MCUs, and host MCUs, which all share a common, easy-to-use development environment with a single core software development kit (SDK) and rich tool set. A one-time integration of the SimpleLink platform enables you to add any combination of the portfolio’s devices into your design, allowing 100 percent code reuse when your design requirements change. Features: Microcontroller Powerful Arm®Cortex®-M4F Processor EEMBC CoreMark® Score: 148 Clock Speed Up to 48 MHz 352KB of In-System Programmable Flash 256KB of ROM for Protocols and Firmware 8KB of Cache SRAM (Available as General-Purpose RAM) 80KB of Ultra-Low Leakage SRAM 2-Pin cJTAG and JTAG Debugging Supports Over-the-Air Upgrade (OTA) Ultra-Low Power Sensor Controller With 4KB of SRAM Sample, Store, and Process Sensor Data Operation Independent From System CPU Fast Wake-Up for Low-Power Operation TI-RTOS, Drivers, Bootloader, Bluetooth® 5 low energy Controller, and IEEE 802.15.4 MAC in ROM for Optimized Application Size RoHS-Compliant Package 7-mm × 7-mm RGZ VQFN48 (26 GPIOs) Peripherals Digital Peripherals Can be Routed to Any GPIO 4× 32-Bit or 8× 16-Bit General-Purpose Timers 12-Bit ADC, 200 kSamples/s, 8 Channels 2× Comparators With Internal Reference DAC (1× Continuous Time, 1× Ultra-Low Power) Programmable Current Source 2× UART 2× SSI (SPI, MICROWIRE, TI) I2C I2S Real-Time Clock (RTC) AES 128- and 256-bit Crypto Accelerator ECC and RSA Public Key Hardware Accelerator SHA2 Accelerator (Full Suite Up to SHA-512) True Random Number Generator (TRNG) Capacitive Sensing, Up to 8 Channels Integrated Temperature and Battery Monitor External System On-Chip Buck DC/DC Converter Low Power Wide Supply Voltage Range: 1.8 V to 3.8 V Active-Mode RX: 5.8 mA (868 MHz) Active-Mode TX at +20 dBm: 65 mA (868 MHz) Active-Mode MCU 48 MHz (CoreMark): 2.82 mA (59 µA/MHz) Sensor Controller 16-Hz Flow Metering: 1.7 µA Sensor Controller 100-Hz Comp A Reading: 1.5 µA Sensor Controller, 1-Hz ADC Sampling: 1 µA Standby: 0.83 µA (RTC on, 80KB RAM and CPU Retention) Shutdown: 125 nA (Wakeup on External Events) Radio Section Dual-Band Sub-1 GHz and 2.4-GHz RF Transceiver Compatible With Bluetooth 5 low energy and IEEE 802.15.4 PHY and MAC Excellent Receiver Sensitivity: –122 dBm for SimpleLink Long Range, –110 dBm at 50 kbps, –103 dBm for Bluetooth 5 low energy Coded Excellent Selectivity: 48 dB at 50 kbps Programmable Output Power Up to +20 dBm Suitable for Systems Targeting Compliance With Worldwide Radio Frequency Regulations ETSI EN 300 220, EN 300 328, EN 303 131, EN 303 204 (Europe) EN 300 440 Class 2 (Europe) FCC CFR47 Part 15 (US) ARIB STD-T108 and STD-T66 (Japan) Wide Standard Support Development Tools and Software LAUNCHXL-CC1352P1, P1-2, and P1-4 Development Kits SimpleLink CC13X2 Software Development Kit SmartRF™ Software Studio for Simple Radio Configuration Sensor Controller Studio for Building Low-Power Sensing Applications

ISO7730-Q1 High Speed, Robust EMC Triple-Channel Digital Isolators

High Speed, Robust EMC Triple-Channel Digital Isolators 16-SSOP -40 to 125

Data-Line Surge and ESD Protection Diode Array 5-SOT-23 -40 to 125